Beautiful little high gain drive pedal to really push your amp.
The cascaded MosFet gain stages give a huge amount of breakup without the need for diode clipping, while keeping noise to a minimum.
The contour control resembles an amp presence control in operation, dictating the amount of punch you're throwing down the cable.
Though not officially touted as such, I'd say this is the right direction to be looking if you want to fill the Orange amp-emulation gap.
Not much else to tell you other than it'd look good in an orange enclosure.
The PCB is laid for vertical-mount pots, but you can also use standard pots and mount them with snipped component legs or header pins. All of these mean the circuit will be mounted sturdily in the enclosure.. Of course, it can be conventionally wired too. Note: if you select vertical-mount pots these have a round shaft, so take that into consideration when buying knobs - you'll need some that fit with a grub-screw.
Partial kit: PCB, all board-mounted components, pots.
Full kit: As above, plus footswitch and appropriate daughterboard/components for your selected bypass type (see Downloads section for details of those), jack sockets, DC socket, battery snap, hook-up wire, LED.
Enclosure (pre-drilled) is only available with full kits, and will take a battery. Knobs are not included.
Builds are only available with full kits including enclosure and vertical-mount pots. Please choose appropriate knobs.
PCB size: 50 x 40mm
Knobs required: 3
Direct-Connect compatible (4-way)
Download INSTRUCTION PDF